Here's an unusual question: Is it possible to disable the radio?

I've got a device that's got a radio soldered on to it so it's not possible to unplug it.  But I'm not using the radio so I'd like to leave the antenna off but I don't want to risk damaging the amplifier.  So, is there an AT command that would allow me to do this?  It looks like you set TXPOWER to 0 but if you do this, is it then safe to disconnect the antenna?

Views: 185

Reply to This

Replies to This Discussion

If you are speaking about the 3DR HM-TRP modules, just set TXPower to low, (1db)  

it's not powerful enough, nor does it have high duty cycle to do any damage even at higher settings.

unplug it?

Reply to Discussion

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service