Distributor

Guys, a very nice project I found on internet, this is a PPM encoder using an Arduino nano and you can use ANY TX module you want to do yourself a TX Joystick or use the PPM signal in your projects.

Credits for this project, construction details and source code on original webpage here

 

I'm doing one of this to test during this week, just amazing project for us, open a lot of possibilities.

 

Guto.

Joystick_LCD.jpgianjtx2.jpgianjtx6.jpgarduino.jpg

You need to be a member of diydrones to add comments!

Join diydrones

Replies are closed for this discussion.

Replies

  • I have ppm encoder and would like to includes inside a FS th 9 X and create a joystick with a cyborg v1 from SciTech anyone have any idea is connecting the ppm encoder channel 32 the cloud or stick of the transmitter and I'll put it on to the transmitter soldered throttle output would make sense
    • Sorry channel 3
  • actually i think this is the right place to thank Ian Johnston the disgner who designed this joy stick as i contacted him earlier and he gave me such a good support and teaching on Arduino that i felt i should thank him publically. not only He is a great engineer he is such a gentleman too!.

     

    Thanks Ian !

     

    Reza

  • This one also can help if you want to use your existing radio transmitter

     

    http://forum.mikrokopter.de/topic-16565.html

     

     

  • Admin

    A nice project. I might have to look into this one!

    A similar project has been carried out over on the Lynxmotion Forum using a Basic Micro processor and a Spektrum DSM2 Airmod: http://www.lynxmotion.net/viewtopic.php?f=21&t=4399

    However, if you don't want to do any soldering, Endurance RC makes the PCTx which acts as a PPM encoder interface between your PC (joystick encoder) and the trainer port of your RC transmitter: http://www.endurance-rc.com/pctx.php

    Regards,

    TCIII

This reply was deleted.

Activity