Hi all!

I'm trying to upload new firmware to my 2.0 APM but when I run the wizard it works for awhile and then throws an error " no communication" right after "Reading Hex".  I'm stumped on what's wrong because I can communicate with the APM when I'm hooked up via USB or 3DR.

Any ideas?



Views: 165

Reply to This

Replies to This Discussion

try another usb port/cable. its most likerly a usb power issue.

Tried switching usb port, cable and computer but it didn't change..

Reply to Discussion



Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service