bootloader - Discussions - diydrones2024-03-28T13:02:56Zhttps://diydrones.com/forum/topics/feed/tag/bootloaderPixhawk not booting normally and Not powered from batteryhttps://diydrones.com/forum/topics/pixhawk-not-booting-normally-and-not-powered-from-battery2020-03-22T17:12:40.000Z2020-03-22T17:12:40.000ZBaligh shreifhttps://diydrones.com/members/Balighshreif<div><p><span style="font-size:12pt;">Hi everybody.</span><br /><span style="font-size:12pt;">Several months building a large quad with pixhawk px4 fmuv2 installed, and long range video transmission, with a gimbal, and powered by a large 22voltsĀ <a>12000</a>mah battery. The whole weight is 4kgs, and the quad flew for continuous 35 minutes. I was very happy about the long flight time and its good stability. Until last week, and just the second flight when I was trying video recording above a lake, and after 5 minutes flight, the quad began to wobble crazily, and I couldn't control it before it was falling into the lake and sunk. After five hours, I was able to extract it from 3 meters under water ,using a water bike and following last GPS position in QgroundControl.</span><br /><span style="font-size:12pt;">After reviewing the log, and connections, I concluded that the cause might be a disconnected wire from the power board which touched the board and caused it to burn, although the ESCs were directly connected to the battery and the pixhawk directly to the power module.</span><br /><span style="font-size:12pt;">I disassembled all the parts,clean, brush,dry.. and I was happy I could recover all of them except for the pixhawk.</span><br /><span style="font-size:12pt;">After first connect to Pc via usb port, it was powered normally, all leds and main light were functionning OK. But I couldn't power it from battery. Another thing was that I could install the px4 firmware on it but not the arducopter and the main led light never lit. And after a stupid try of installing px4io bootloader from sd card, the pixhawk was no longer seen from MP or Qgroundcontrol, I tried the python loader , it gave a message "waiting for the bootloader" although I tried to hold switch while powering the pixhawk.</span><br /></p><p><span><span style="font-size:12pt;"><strong>Note:</strong> the leds status when connected to pc in normal mode</span>:</span></p><p><strong>IO POWER AND FMU POWER:ON</strong><br /><strong>IO B/E: ON</strong><br /><strong>IO Act: blinking</strong><br /><br /><span>When in boot mode</span><br /><strong>IO POWER AND FMU POWER:ON</strong><br /><strong>IO B/E:blinking</strong><br /><strong>IO Act: OFF</strong></p><p><strong>Images before a<a href="{{#staticFileLink}}5334413883,original{{/staticFileLink}}" target="_blank">20200212_215731.jpg</a>nd after crash and log file are attached</strong><br /><span>Any help to recover my pixhawk back and also resolving powering problem from battery will be really appreciated.</span><br /><span>Thx in advance</span></p><p class="attachment"><a href="{{#staticFileLink}}5334414098,original{{/staticFileLink}}" target="_blank">20200317_154851.jpg</a></p><p class="attachment"><a href="{{#staticFileLink}}5334414853,original{{/staticFileLink}}" target="_blank">20200317_175513.jpg</a></p><p class="attachment"><a href="{{#staticFileLink}}5334415055,original{{/staticFileLink}}" target="_blank">CrashLog.rar</a></p></div>