FMK24-L5200 Altitude Holding Radar For Drone Flight Controller

Product features:

 

.Special model for drone altitude holding,has advantages of light weight,small volume,easy installation

.24GHz microwave altitude holding radar is your preferred altimeter for flight controller

.Special radar for Drone/UAV, weight is only 34 g,which is suitable for altitude holding flying usage in most case

.FMK24-L5100:For single target,suitable for ground altitude holding flying

.FMK24-L5200: For multiple targets,suitable for terrain following flying

 

Product Parameters:

 

 .Tuning Frequency:Min.24.000 GHz,Max.24.500 GHz

 .TX power Eirp:Min. 0dBm, Typ. 6 dBm, Max.10 dBm

 .Modulation type:FMCW

 .Range-measurement range:Min.0.5m,Max.30m

 .Range-measurement accuracy:Min.-0.05m,Max.+0.05m

 .Range resolution:0.01m

 .Antenna pattern HOR:26deg(-3db)

 .Antenna pattern VER:26deg(-3db)

 .Supply voltage:Min.10V,Typ.12V,Max.24V DC

 .Power consumption:400mW

 .Updating rate:10Hz

 .Storage temperature:-40~+85℃

 .Operating temperature:-20~+80℃

 .Weight:34g

 .Dimensions:74*46*30mm

Views: 302

Attachments:

Reply to This

Replies to This Discussion

I wonder if the protocol that it operates already exists any similar in the standard ArduCopter firmware, if so, which one will I use? Is Rngfnd_type and whether Lidar360's Serial_Protocol will fit well, or do we have to make one?

Reply to Discussion

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service