Discussions

help plz??

Posted by Mansi Alenezi on August 24, 2011 at 8:40pm

hello everybody i have problem am trying to make

arducopter traditional helicopter

my problem i connect the rc receiver and in apm mission planner it get the signal

but the problem when am trying to connect my servos with apm

the rc receiver flash red and light then the light goes and nothing happen to servos
also the calibration in apm mission planner stop working i don't know what's the problem but if i remove the servo wire rc receiver start to work again any one can help me plz.  

3690885986?profile=original3690885592?profile=original

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • 3D Robotics
    Chris Anderson August 24, 2011 at 9:06pm
    Sounds like you're plugging your servos in upside down or otherwise wrong and causing a short. Try again, one servo at a time and see if you can isolate the problem one.
This reply was deleted.

Activity