Hi everyone I'm having a problem with setting up power mangement with ArdupilotOne (ardurover):

http://code.google.com/p/ardupilotone/source/browse/#svn%2Ftrunk%2Fardurover

 

I was looking at the ardupilot mega wiki on how to configure the voltage sensor for high voltage setups:

http://code.google.com/p/ardupilot-mega/wiki/VoltageGuide

 

and they said to change some configuration settings (voltage divider ratio etc) in the source files. I can find these settings in ardupilot mega source so that I can change it but not in the ardupilotone source (ardurover) which is what i'm using. Is battery monitoring not supported in ardupilotone or am I not looking hard enough because I looked through the source and just cant find it.

 

Is there anyway I can setup power management (battery monitoring) with ardupilotone?

 

-Junior

 

 

 

 

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • Isn't it just soldering a new resistor in?  If I understand it properly (and I probably don't :-P ) your voltage divider should always output 5V if the batteries are charged.  If not, the divider outputs less than 5V and if it crosses a threshold you declare the battery dead.  Why change the settings?


    MIKE

This reply was deleted.

Activity