Hi,

I am interested to send some high-level control commands to pixhawk using MAVLink, indoors. So, I have a motion capture system setup which gives accurate XYZ and orientation. I would like to tell pixhawk this information in order to use it onboard instead of e.g. GPS. How can I do that?

I think there is a way to do it by sending a MAVLink message to tell Pixhawk use these position/orientation data, but have not figured that out yet!

I appreciate any help.

Thanks.

Views: 897

Reply to This

Replies to This Discussion

PX4 Firmware solved the problem. It already supports vision/MOCAP.

Hi Mohamed, I am a student and building a quadcopter which I want to fly indoor. I have the same problem as you mentioned. Could you please tell me the procedure how did you solve it using the PX4 firmware 

Reply to Discussion

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service