UPDATE: See the manual.

Hey guys, this is mainly a question for our friends at 3DR, but anyone who has looked at the traces on the APM2 daughterboard, and knows the GPS module, could offer ideas.

I wonder what you'd think about (as a hack, as a revision to the APM2 daughterboard, etc) installing some jumpers or switches to "disconnect" the onboard GPS, as needed. We might also add a battery socket to maintain the almanac, for those who want to accept the extra weight of the small battery, but that is another topic.

I have a small but growing fleet of APMs, some APM1 and some APM2s. However, I never have enough, so I find myself swapping them around as needed. I leave the magnetometers, air speed sensors in place and connect them as needed. Some airframes are better served with an external GPS, but I would prefer to have all my APM2s be, physically, the same. That is, I'm willing to buy all my APM2 with the extra cost of the onboard GPS whether or not I need it, in order to ease my "fleet management" if you will. If the daughterboard were not soldered in place, I might instead get extras, but this approach might work best.

However, I would also like to buy or use uBox and other external GPS units, as needed. I think this represents opportunities for the 3DR and affiliate stores. Many users will purchase the APM2 w/GPS, and some will later decide they want to use an external. Some will buy a separate unit w/o the GPS, but most will not. Most of the population simply live with the existing GPS. However, if there were a switch or jumper(s) to kill the onboard GPS, then casually swapping to an external GPS (and, casually purchasing additional GPS units) is easier. It also allows for subsequent upgrades (opportunities for sales) to future GPS units. 

As a hack, are there recommendations on which trace(s) are best to cut and/or install a jumper for an existing APM2? I imagine there are a couple of ways to do this, not all are ideal. Is there any merit to a revision of the APM2 where there is a jumper or switch for the GPS? 

Thoughts? 

Views: 5949

Reply to This

Replies to This Discussion

Hi Chris. I too am working through GPS lock issues. (only since 2.6 FW).

 Will there be the ability to just purchase the daughterboard separately with only the Flash mem onboard. Then we could simply swap it out, and use an external GPS module. No mess, no fuss, no hacking traces, bridging with Resistors etc.

thanks very much

Owen

The manual has been updated with a recommendation by Jani, easier and simpler than (and similar to) some of the ideas we've been playing with here. 

Reply to Discussion

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service