Linux-based Quad-Rotor Control

Hi Everyone,

just want to highlight our most recent developments on PenguPilot, a GNU/Linux based Multi-Rotor UAV Autopilot.

A Video with horizontal GPS position stabilization and vertical ultrasonic stabilization is avaliable here:

Gumstix Overo and Linux based PenguCopter from Tobias Simon on Vimeo.

The whole control process is implemented in C under Linux (PREEMPT Kernel). The latest source code is available here:

https://github.com/PenguPilot/PenguPilot

IPC among C and Python processes is implemented via ZeroMQ and MessagePack/Protobuf.

Regards, Tobias

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • robot challenge 2015

    gratulation zum gold im air race rennen!

  • Hi Tobias,

    could you tell approximate hardware setup for Gumstix Overo? It's hard to grasp completely from github repo which hardware you use with Overo. I mean sensors, etc.

    • Hi Aleksandr,

      - we use the 4 Timer/PWM outputs of the Gumstix for motor control using the OMAP3-PWM driver.

      - Drotek MPU6050/MS5611 Sensor board is connected to the Gumstix's I2C Bus 3.

      - Maxsomar I2CXL ultrasonic Sensor is connected to I2C bus 3 as well.

      - LEA-6 GPS receiver is connected to ttyO0 (NMEA output at 115200 baud, 10Hz update rate)

      - ACT DSL remote control receiver connected to ttyO2

      - Current Sensor connected to ADC channel 7

      - Voltage measured via ADC channel 2

      - Internal WiFi of the Gumstix für SSH

      3702500867?profile=original

      Cheers, Tobias

This reply was deleted.

Activity