I have problem to set up MinimOSD together with telemetry system on APM board.

  1. APM 3.0
  2. MinimOSD 0.1v
  3. Boscam Aerial camera
  4. Boscam 5.8G Diversity Receiver 7.0 Inch TFT LCD Monitor
  5. Boscam 5.8 200mw 8channels FPV Wireless Transmitter

Wiring diagram that I used:

 http://www.rcgroups.com/forums/showthread.php?t=1810347

From time to time I get short signal but suddenly it disappears. Telemetry works fine over “Y” cable.

Thanks!

Views: 334

Reply to This

Replies to This Discussion

Check you video output. PAL or NTSC. I had the same issue and and when I set the output of the camera to NTSC it solved my problem. Hope this helps.

Reply to Discussion

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service