Hi all,
I've set up 6 modes on my Futaba 7c according to the instructions in the wiki.
When I check in the CLI they all list correctly as I change the switch combinations. When I connect to mission planner via xbee only mode one and two will show correctly. I have set mode 1 to Stabilize and 2 to Alt Hold.
When I switch to modes 3 to 6 they all say they are set to Stabilize. I thought perhaps they hadn't been programmed properly so I connected via CLI again. All positions showed up correctly. Is this a problem with mission planner or with my radio I wonder ? I can only confirm that modes 1 and 2 work correctly as the area I was flying in yesterday was too small to try the other modes. I hope to do some proper testing tomorrow, weather permitting.
Any thoughts ?
Regards
Eoin

Views: 209

Reply to This

Replies to This Discussion

you havn't mentions what version firmware/mission planner you are running?

Hi Michael,

I'm using Mission Planner 1.0.96 with firmware 2.0.50

Unfortunately no opportunity to fly today. Gale force winds and rain outside, so I can't confirm if the other modes are actually working or nor. According to the CLI they are.

Thanks

Eoin

Reply to Discussion

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service