Anyone please help me to configure the arduino sketch for my ESC and Brushless Motors. The build is a quadcopter X. I need the MINTHROTTLE, MAXTHROTTLE and MINCOMMAND to arm the motors. The current values are 1150, 1850 and 1000 respectively. The motors do not responds to the ESC with this configuration.

The ESC and Motor specifications are attached with the post.

Views: 260


Reply to This

Replies to This Discussion

I have the same problem!! did you find a solution?

Reply to Discussion


© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service