Hey Guys..
I have this Motor, ESC, Battery , CW Props
I have Arduino Uno doing all the processing and running the program. But, the problem is My quadcopter is barely moving. I am pretty sure I have my props setup is right. Any Ideas ?
Hey Guys..
I have this Motor, ESC, Battery , CW Props
I have Arduino Uno doing all the processing and running the program. But, the problem is My quadcopter is barely moving. I am pretty sure I have my props setup is right. Any Ideas ?
You need to be a member of diydrones to add comments!
Replies
You must run 2 cw and 2 ccw props on the correct motors, (two motors will spin cw, two ccw) or the apm will reduce lift to try and compensate for yaw. A 2200 3 cell should be a good bet. If you have two batteries you could try and run them as a 4 cell to see what happens (but your props may be too large at that voltage). Keep an eye on motor temp. Good luck.
Not sure but hopefully you also have ccw props and a 3s battery, it will not fly on 2 cell. What's the all up weight?
Hey guysss... It seems no one is replying to this discussion ... I am a newbiee... Please let me know if I am not wording my question righttt ... Or if need more infooo....