Hey Guys..

I have this Motor, ESC, Battery , CW Props

I have Arduino Uno doing all the processing and running the program. But, the problem is My quadcopter is barely moving. I am pretty sure I have my props setup is right. Any Ideas ?

Views: 426

Reply to This

Replies to This Discussion

Hey guysss... It seems no one is replying to this discussion ... I am a newbiee... Please let me know if I am not wording my question righttt ... Or if need more infooo....

Not sure but hopefully you also have ccw props and a 3s battery, it will not fly on 2 cell.  What's the all up weight?

Hmmmm... I do have a CCW props, But Haven't tested with it since it is only for YAW control right??. I don't know the exact weight but I am using this frame. It is very light. I am sorry I couldn't give you exact number. I will get that very soon. Ok 3 cell then. What do you recommend  for 2200 mah/ 5000 mah? And, do you think this Props is suitable for the copter or any suggestions..

You must run 2 cw and 2 ccw props on the correct motors, (two motors will spin cw, two ccw) or the apm will reduce lift to try and compensate for yaw.  A 2200 3 cell should be a good bet.  If you have two batteries you could try and run them as a 4 cell to see what happens (but your props may be too large at that voltage).  Keep an eye on motor temp.  Good luck.

Reply to Discussion



Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service