Discussions

New Hex set up 2.6 can only get 4 motors to run is there some parameter to change frame types

Posted by Eric Strickland on October 30, 2014 at 7:34pm

Hi,

I am setting up a 2.6 with hex everything configured but, I can only get 4 motors to work. motor output 5 and 6 have nothing.. in MP where you can see the motor out put I only see 4.. I checked by plugging the other two ecs and motors into one of the working four put puts and they work fine.. using 3.1.5 arducopter..

Thanks for the help.

You need to be a member of diydrones to add comments!

Join diydrones

hex, motor, problem

Email me when people reply –

Replies

Scott Reid October 31, 2014 at 10:11am

There's different firmware builds for each frame type. Do initial setup in mp to upload the correct one.
- Eric Strickland > Scott Reid October 31, 2014 at 4:03pm
  
  ahhh i found it txs very much

This reply was deleted.

Activity

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.