Hi

I am a complete noob at this, I have built a octo using APM 2.5, my problem is the throttle seems stuck, it starts up at a high speed but when you try to increase it just stays at the same speed.

 

I think I am having the same problem in this thread, tried everything and still cannot get it to work, Any help please.

http://diydrones.com/forum/topics/problem-no-throttle-control-on-ar...

Views: 1344

Reply to This

Replies to This Discussion

Thanks Mike

I nearly had a flyaway for some reason, it just went in to full throttle and was not responding, the only way I stopped it was using the 3 button switch and switching it to rtl then it stopped? I then started over again by erasing the apm and the model in the tx and so far all my problems have gone except in loiter mode she takes off forward for some reason but everything else works.

Reply to Discussion

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service