Hi Guys,

I have a small issue.
I have a small project with a basic stamp BS2px and the serial servo control board.
Sometime when I run my code I need to press the reset button on the servo control board for the servos to go to their positions. When it happens it is always at startup. Once reset it runs fine.

Is there a way to reset the servo controller via the program or a way to set it up so it does not need to be reset?

Thanks

Views: 218

Reply to This

Replies to This Discussion

Try using a wait statement at the front of your code prior to sending the first command.
I did that and also sent a command at the beginning of the code to set the default baud rate of the PSC and it worked! Thanks.

Reply to Discussion

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service