Pinout of Pixhawk telemetry plug

3691090896?profile=originalI'm sure this question will be answered eventually in the wiki, but say someone wants to use the older style 3dr radios.  What is the pinout of the pixhawk telemetry plug?  The other end of the pigtail will be cut and soldered directly on the radio. Red is 5v.  The black are unknown.

http://pixhawk.org/_media/modules/px4fmuv2.3.pdf  Here?

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • This was helpful although I did make the mistake of not reading the TX and RX close enough and got it backwards. RX is 2 TX is 3.

  • Thanks for the reply peter. You basically wired it up like the picture below? I will try this out tomorrow and confirm.

    image.jpg

  • 3692921631?profile=originalis this it with #1 being on the left of the pixhawk?

This reply was deleted.

Activity

Liam left a comment on Agricultural UAVs
"Hi
I'm Liam from T-MOTOR. I would like to reach out to see if there is any possibility for us to work together.
We are a propulsion system manufacturer who offers motors, propellers and ESCs for all kinds of drone applications which vary from secur…"
Jun 30
Richard Cox left a comment on Australia
"Anyone in the DIYDRONES Australian subgroup based in Alice Springs, NT?
I am experimenting with Ardupilot (standard Arduplane), Pixhawk 4 FC in a 4-ch
RC "AXN Floater Jet" foamy plane..."
Jun 29
Omar Sykes left a comment on Australia
"Hi everyone, I am looking for someone who is good at drone building, repair and software in Adelaide. Please give me a call on 0477 319 219."
Jun 29
More…