Hi everyone, I hope this is the right place to ask this question

In my pixhawk an issue happened suddenly , I can't connect it to my PC

( the middle flash stay steady which indicate some I/O problems as I understand )

I checked the voltage regulator and I noticed that the output is 4.7 volt

also I checked the I2C (Vcc and GND) and it gives 4.7 volt also

I think the voltage regulator has broken, does that relate to the usb connection ? or I must check something else ??

I fear that something else has an issue and it destroyed the regulator ??

Any ideas ??

Thank you very much

Views: 82

Reply to This

Replies to This Discussion

After re checking the regulator voltage it seems that I read the output wrong , so regulator is fine , but I still can't connect my pix to the computer.

Reply to Discussion

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service