It seems impossible to set the power monitor.

No matter which options i use, it is impossible to save the Amperage reading.

Without this it is impossible to do the motor to compass calibration.

This problem is happening both for Clone Pixhawk as well as for the Pixflacon Power module.

The voltage i manage to to do OK but seems impossible to to save the Current value. I enter it and when going back it changes to NULL.

Please help

Views: 193

Reply to This

Replies to This Discussion

I think there is a value at full parametrs for changing the Amper


You should change this value and write params

Reply to Discussion


© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service