I have experience with the KK2 and the CC3D but am new to the APM 2.5 which has many more features and capabilities.  I have built a new H copter and installed the APM 2.5 board.  I was wondering if there is any special power up sequence with the following hardware on my quad?

  • APM2.5
  • Rx
  • GPS w Compass
  • MAVLink OSD
  • 3DR radio
  • ESCs

Or can I just connect the battery and go?

Thanks

Views: 157

Reply to This

Replies to This Discussion

As long as you've done the setup and calibration (http://copter.ardupilot.com/wiki/initial-setup/) you can just connect the battery and go.

There's no specific power-up sequence - the parts are designed to be powered up at the same time.

Reply to Discussion

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service