PX4FLOW Board and Pixhawk

Hi to all

I have just bought a PX4 Flow module with sonar sensor and connected to my Pixhawk board using the i2c cable. I've followed the instructions in this wiki page.

Actually I can't see any data from the OF, neither in the telemetry nor in the log file (I set the log bitmask as LOG_BITMASK = 131071). The Sonar too seems not to work. I tried to enable it from the "initial settings" but still have no response. Of course the board is ON and I updated its firmware using QGroundControl.

Have anyone faced the same issue? Thanks

3691222289?profile=original

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Activity