if those are the power wires for the motor the worse that happens is the motor turns backwards. At that point you can either reverse the direction in the software, or swap any 2 of the three wires around and the motor will reverse directions. Power wires are generally in singles or doubles, motor wires are triples, and the mpu sensors are generally 4 or more wired cables. Look on the back of the board if it is the mpu sensor wire and see if you can find the silkscreen on it, and most of the mpu sensors run the same wire pattern so if you can find one diagram it should work for yours too.
How yours DYS3 axis working. I fix my Tarot 2D after I change motor, suspension plate, and still have problem at tilt. It jittery at one point and and cannot adjust it. I will like to change to DYS 3axis. I know you have put up at last thread but I did not save it. If everything working fine with yours can you please email to me how it wiring and set up.