Hello everyone,

I am using a Traxxas Slash vehicle-- as the one I am showing in the link:

https://drive.google.com/open?id=0B4rmg ... GpYWC02Nlk

I followed the setup from the wiki. However, the car does not move forward just the steering on Manual mode. . I had been going over the forum and found out I have to do an ESC calibration like in a quadcopter. If so, is the process the same?

Also, I am using Turnigy 9x Radio and receiver. On Mission Planner doing the Mode Setup, I am only able to get one mode and not the others as described in the wiki. Do I have to do the setup for modes on the Radio? If so, is the process the same as for a quadcopter.

Thanks for any help provided.

Virgil

Views: 327

Reply to This

Replies to This Discussion

@Virgil,

You will get a lot more exposure for your Rover issue if you join the ArduRover User Group and post your issue there in the Discussion Forum.

To help troubleshoot your issue you might want to provide the following:

Navigation Controller: AMP or Pixhawk

Version of ArduRover firmware

Transmitter/Receiver

tlogs or dataflash logs

Regards,

TCIII AVD

Reply to Discussion

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service