Discussions

Turnigy9X / Pixhawk and a quad battery question

Posted by Brady D on May 6, 2014 at 5:32am

----------Turnigy and Pixhawk----------------

I have done a previous project with the old APM and Futaba radios which ran a jumper for each channel from the Rx to the APM. I am about to bite the bullet on a Pixhawk and would like to use the Turnigy 9X since it is cheap and I no longer have access to the Futaba Radio. I want to take advantage of the single cable from the Rx to the Pixhawk. Is the 9X capable of this?I have searched the forum and people mention the two but I can't find a picture of an actual setup working.  

https://www.hobbyking.com/hobbyking/store/__8992__Turnigy_9X_9Ch_Transmitter_w_Module_8ch_Receiver_Mode_2_v2_Firmware_.html

-----------Battery Question--------------

I have done several fixed wing projects, but I am now looking at a Flamewheel 450 quad ARF. I have no clue how to size a battery for a quad. Anysuggestion on cell count, or mAh. What is the typical current draw during flight aka how many C battery should I be looking at? Right now not looking for FPV or any real payload, but would like a decent flight time.

Thanks 

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Brady D May 6, 2014 at 5:12pm
    Got the radio question solved. But still would like to know some rules of thumb on quad propulsion sizing
    Thanks
This reply was deleted.

Activity