I had changed some code from Copter3.3.3, built it using "make px4-v2". After uploading it to a pixhawk using missionplanner, the pix can not connected to the computer by usb cabel ,it continuous restart after 2 or 3 seconds again and again,of course I can't upload firmware again. What can I do now? Can I repair it?...I had built other hex firmwares, they all worked well excepted this one.
You need to be a member of diydrones to add comments!
Replies
try holding the safety switch and then while still holding it power up the hawk and wait a couple of minutes. Then power down, release switch and power it back up. And by holding it I meant pushing the button :)
Thanks very much ,I had tried as you ,but it did'nt work.
At the end ,i pulled th tf card out ,and it can be connected to the computer,then I update a new firmware to it ,It works well,