I made a printable case for my 3DR radio "air" module:

www.thingiverse.com/thing:40483

 

And a case for a Spektrum AR 6100e receiver:

www.thingiverse.com/thing:40484

Views: 644

Replies to This Discussion

Carl,

Here are some pictures of how your 3DR radio box came out.  I downloaded the .stl file from thingiverse.com, then uploaded it to shapeways.com and they made it into a nice precision part set. 

The only change I plan is to use a small piece of clear film to prevent moisture from entering through the top.

Thanks for sharing!

Attachments:

Nice: Just a FYI, it's best to embed images with the little picture icon, so that people can see them inline. Like this:

Sure looks nicer than what my Printrbot produces.

I made a box for the ground module too.  http://www.thingiverse.com/thing:41536

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service