As a total noob, I'm sure it's staring me right in the face lol!  I'm setting up an X8 flying wing and even after selecting elevron mixing the elevator and ailerons still operate separately.  The instructions for the mission planner say to click on "save".  I don't see save anywhere in the window.

Thanks!

Views: 198

Replies to This Discussion

Hi Shaun,
Are you referring to the radio calibration screen for the elevon settings? Or are you referring to the elevon setting in the advanced Params screen?

Have you configure elevon mixing in your transmitter or are you using the new elevon mixing in 2.73

R

I'm looking at the radio calibration screen.  I was following the quick start guide for setting up the radio.  It said not to mix the elevon in my radio, but to do it in the calibration screen.  It's selected, but the channels are still separate.  I'm using firmware 2.73.  Thanks!

Hi Shaun, check out this if you haven't already:
http://plane.ardupilot.com/wiki/arduplane-setup/first-time-apm-setu...

Cheers Paul

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service