i find it tough enough to take off my finwing penguin. Its balanced and i takeoff in manual. usually i'm on my own and if there is someone to help then they have 0 experience.
I dont really want to use the auto take off feature.
What i currently do is - Aim into wind. Manual mode - trim elevator up 100% and give it 50% throttle. then i grab the controller and try to add elevator and 100% throttle. 30% of the time this works. The rest it dives into the ground and eventually does damage of some sort.
Could i just use stabilize mode or alt hold mode under the same conditions - would this make the APM keep the plane level after throwing or are there any other tip that can get my takeoff skills to 100% success.
I'd recommend using the auto take off feature - it works great. Any reason you don't want to use it?
I would think of a bungee launcher or a catapult for maximizing your take-off success rate.
so do you setup a flight switch as takeoff and just throw it ?
We always use auto takeoff although not specifically with the Finwing but with the Super Skysurfer. It's reliable and foolproof if done correctly. In 500+ day and night launches we've had a failure rate of about 0.012%. We've set it up so that as soon as Auto mode is enabled via a switch on the Tx the motor starts straight away which is confirmation to launch. A takeoff mission item is first in the mission plan with pitch set to ~12° and altitude 70m (As described here: http://plane.ardupilot.com/wiki/flight-features/automatic-takeoff).
A bungee or catapult helps a lot if your plane is heavy or you're not so comfortable with throwing. Important thing with either method is to throw the plane level at the horizon, do NOT throw up or nose high, the autopilot will sort out the pitch angle and climb when it's ready.
I have a penguin too loader with fpv stuff and 10 000 ma lipo. I throw it with my right hand without running. Rc is in my left hand. Motor is at 90pct, everything else is untouched.Stay in manual mode until this works 100 pct of the time. Perfect trimming when flying, then do not touch it anymore.
Where is the CG of the plane ? Should be about 22 percent of the chord of the wing, very much ahead of most planes.
Only when you are fine then think about using the apm. But make sure that the elevator works the correct way when you move the plane with your hand as it may be moving the wrong way.
Would fbwb work?
I use FBWA too it's great.
I have a flaps switch in my DX8 radio that you can adjust to add some (about 30%) up elevator (I don't have flaps so I just adjust the elevator part). You can use in-radio-mixing to use any switch for the same effect. (It's probably cleaner than using trim as you're doing, but that would work fine too.)
You don't need to be quick to get your hands back on the controller as FBWA does a very good job of keeping wings level and maintaining the climb.
I've used that approach on FPV Raptor, Bormatec Maja, Cyclops EPO and Go Discover.
The big advantage is that it's just three steps, no mission planner programming needed.
No. Have a read of this wiki page. It has everything you need to know.
Let us know how you go. Video's always welcome :-)
i bought pixhawk and now i am hesitating how can i set the FBWA mode to my plane.
would you advise me the method or procedure for me?