Hello All,

Someone could help me, i can't manage to make the RC6 as a release parachute on Pixracer and Arduplane 3.7.1???

I'd configure the channel 7 on my taranis and in MP in order to released parachute, it's seems working as when i arm the plane and switch parachute i have "parachute released" on MP , but the motor don't stop???

I have set RC6 as 27 function (parachute release).

But the parachute servo don't move (never) as it don't have any signal??? (just a little toggling on power on) 

if i playing with toggle servo 6 in flight data servo tab in MP: nothing...

i'd plug the parachute on a aileron servo,just to be sure that it's ok and it working great???

Does some one have any idea, what i miss?

Views: 156

Replies to This Discussion

I do the answer,

it's not possible (maybe for the moment ;-)  ) to use a Pixracer for plane with parachute :-)

I'd change it for Pixhawk and lost place but with parachute on rc9 everything are ok.

Ohh :)
Want to know, did you make ch6 in taranis functioning? 《 just what i supposed :)
Good luck
Happy droning :)



Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2018   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service