Hi all, as some of you might remember I was having a problem with my survey boat zig zagging terribly while carrying out a mission.  At first I thought it was a Mission Planner parameter setting, but it turned out to be the little L298N H-Bridge failing due to excessive heat.  This was caused by me upgrading the outboard motor to a Suzuki 2.5hp four stroke which turns out to have a LOT more drag on the pivot (steering) column.  This drag put extra stress on the little 2A H-Bridge causing it to fail intermittently. 

The solution was to upgrade the H-Bridge to a 10A H-Bridge, but being in South Africa, none are available locally so I built my own from this diagram - 

Unfortunately when I connect it to my PWM output from an old rc servo motor, it appears to go into a DEAD SHORT.  Clearly I am doing something wrong here.

Can somebody please help me here.

Here is my setup - 

Views: 305


Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service