I have a pixhawk fc and a turnigy 9x with a PPM encoder.....my problem is i am unable to get the 3 position switch to work.........works fine with my APM builds.....i am currently using my Cheerson cx-20 TX/RX and it works fine on the pixhawk....all flight modes work....but no luck with the Turnigy 9x and Pixhawk....i do not want to have to use a separate TX/RX on apm and pix both...can anyone please help?

I have followed this diagram exactly....i even have the same receiver and ppm encoder

Views: 542

Attachments:

Replies to This Discussion

Hi Leo,

it seems that your 3 positions switch is not configured. These 2 postes will help:

http://diydrones.com/profiles/blogs/configuring-turnigy-9x-with-ard...

http://diydrones.com/profiles/blogs/mode-switch-setup-for-turnigy-1

good luck

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service