Hi all, I have a skid steer robot using a pixhawk cube, one 1x15 roboclaw motor controller and a dagu wild thumper 4 wheel chassis. I have skid steering working so far, testing motor c and motor d tests works as described and the vehicle can be contrRead more…
I have converted a Traxxas X-Maxx into a rover using the Pixhawk Cube 2 controller kit with a Here GNSS.I swapped out the original X-Maxx remote controller for an X6R receiver and Taranis QX7 radio.
latest version of ArduRover firmware installed asRead more…
I know this is an Adurover group, but Thought I would reach out and try my odds for some help as I'm perplexed by this problem.
I have a Traxxas X-Maxx set up with a Pixhawk Cube 2.1 and the Here GPS. I'm using a Tarranis X7 remote controllerRead more…
I cannot find FailOptions in FailSafe setting page of Mission Plan.
it is different below page.Read more…
I have problem to bind FS IA8B receiver by FrSky x7 transmitter.
The red light is blinding slow, after press [BND} on FrSky x7 transmitter, the red LED light is still blinding.
How to bind the FS ia8b receiver from transmitter?
I found the videosRead more…
I have created an ArduBoat system using Pixhawk, 2x motors with carbon AirProps from a 15" Octocopter withouth a rudder
I have installed ArduRover 3.2.3
I have really difficulties in setting the steering, maybe someone can help me.
I would likeRead more…
I'm trying to control my Rover with a Raspberry Pi.
I followed all instructions to set mavlink connection and to set dronekit up.
It indeed connects! I can star motor, see a plenty of parameters, but home location or local location. ItRead more…
I have a 12 volt geared motor driving my power steering on a John Deere 5055e. The Pixhawk channel 1 output is going into a JRK12V12 motor controller which is receiving angle sensor input from my AG Leader steering angle sensor. I have consistent RTRead more…
I want to transform my old RC car, i have the APM and everything that i need to transform, but i have some doubts about how to power it.
First of all my ESC is a Hobbywing xerun 120A : http://www.hobbywing.com/goods.php?id=350
And im using
I have a boat running Ardurover 3.1.2 on pixhawk in skid steer out mode. I want the boat to turn on the spot without moving forward or backwards.
At the moment full left or right stick on the transmitter produces at a guess 10% rear thrust andRead more…
I want to assemble a rover run with APMrover2.
Here are the links I found on Amazon.
The objective is to build an autonomous gravity racer (no motors, just rolling down a hill) to go through several waypoints. Autonomy through GPS and magnetometer.
Was wondering if anyone can direct me a little in terms of how the coding to control thRead more…
This is my first attempt for rover with ardurover 2.8 using a cheap crawler. I found a normal rc motor steering style at front at rover so I replaced with Professional SG90 SG90 9g Micro Servo
I followed all the instructions on the ardurover.org dRead more…
I have a pixhawk controller and trying to layout the follow me options. As far as I can tell the only mobile GCS that provides "follow me mode" with the controller is Tower's android based GCS. Is there any others people are using?
I also read thisRead more…
I'm currently working on a project rover project that would basically consist in a 4 wheels vehicle with no steering servo. The vehicle would turn and rotate by having motors on each side spinning in an opposite direction.
As almost all ArduRoverRead more…
Note: this page contains paid content.
Please, subscribe to get an access.