Has anyone found a good internal-tooth washer and nut to fasten the prop to the motor?

I tried some M5-0.80 hardware from Lowe's based on 3DR's website, but it doesn't seem to fit properly.


When the Iris lands in tall grass or something touches the prop, the nut and washer often fly off so I think it would be useful to find local hardware for replacements.

Views: 178

Replies to This Discussion

Use Loctite. or a locking castle nut

I bought the #10-32 nut and #10 washer from Home Depot. It works perfectly, but I also needed to purchase the 3/8 Husky wrench. See picture. 




Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service