Crispin's Discussions (207)

Discussions Replied To (18) Replies Latest Activity

"wha?! and get the truth? noooo, "the internet said so" :p"

Crispin replied Apr 11, 2016 to Pixhawk being replaced with new version?

40 Apr 21, 2016
Reply by gervais

"VR Brain has been around for a while. I would try that. My issue with the RPi offer…"

Crispin replied Apr 11, 2016 to Pixhawk being replaced with new version?

40 Apr 21, 2016
Reply by gervais

"BYOD or UMTech? It's a pity if it's true. I would rather not buy copies from HK or…"

Crispin replied Apr 11, 2016 to Pixhawk being replaced with new version?

40 Apr 21, 2016
Reply by gervais

"If you have a Pixhawk with 3.3+ and the buzzer connected the it beeps to confirm the…"

Crispin replied Apr 1, 2016 to Flight mode confirmation???

34 Apr 7, 2016
Reply by John R

"In advanced params in mission planner there is the option to for the servo - set it…"

Crispin replied Mar 30, 2016 to Pixhawk with Servos

12 Jun 11, 2016
Reply by Evan Palmer

"Most odd Marc. The Hobby King Blue 40A ones I had certainly did not like the low KV…"

Crispin replied Jul 22, 2015 to Pixhawk and some ESCs with Low KV motors. Pixhawk is not the problem. Problem is related to ESCs, Firmware and fine tuning.

91 Apr 26, 2016
Reply by ActionDrone

"it's not all bad... I had 6 HK 40A blue series with a pixhawk and it was impossible…"

Crispin replied Jul 22, 2015 to Pixhawk and some ESCs with Low KV motors. Pixhawk is not the problem. Problem is related to ESCs, Firmware and fine tuning.

91 Apr 26, 2016
Reply by ActionDrone

"Correct - sort of. You can connect MinimOSD RX to your telemetry TX. Don't connect…"

Crispin replied Jun 12, 2015 to Telemetry connection question.....

7 Jun 20, 2015
Reply by David Kershaw

"That's a bummer... When you say "Would not disarm" is that after an auto landing? I…"

Crispin replied Jun 7, 2015 to Motors pulsing in position hold - Any ideas?

9 Jun 7, 2015
Reply by Crispin

"Did you have any joy getting to the bottom of this? I've got the same on a new frame…"

Crispin replied Jun 7, 2015 to Motors pulsing in position hold - Any ideas?

9 Jun 7, 2015
Reply by Crispin

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service