All Discussions (257)

Sort by

RSSI

Good day all

As you may have seen on other discussions, I have completed phase-II of my second drone.

Just to recap my setup:

F450 frame
2312 motors
Bl-Heli32 (40A) ESC
9450S props
RXSR Frsky receiver
Pixhawk 2.4.8 ( running APM copter V3.5.5 )
M8N GPS
CADDX T

Read more…
1 Reply

Prioriy levels for flightmodes

Good day all

I am busy building my second drone :

Setup:

pixhawk

2312 motors

9450 propellers

M8N GPS

RXSR receiver

I have done a successful maiden flight, but I would like to test some of the autonomous

flight modes as I have programmed into the pixhawk. I am

Read more…
3 Replies

RTL function on pixhawk

Good day all

Busy buidling my 2nd drone.

Using a pixhawk and would like to get clarity on the RTL function.

I have seen many videos on the RTL function so I know what the drone does.

My question is about the activation of the RTl mode. If I program chann

Read more…
2 Replies

Pixracer Power Cable

Does anyone know where can I buy the power cable to connect the Pixracer power port to ACSP4 power module directly?

The cables I received with Pixracer and the ACSP4 module has one connector that can plug in properly but the other end has different st

Read more…
2 Replies

Lipo Battery Cut off System

The PixHawk along with Mission planner allows us to set battery thresholds and we can make a Quad or plane to do RTL, land etc. if the battery voltage drops below predefined thresholds.

I am wondering if there is an external battery cut of a system th

Read more…
5 Replies

Flashing Pixhawk 2.4.8

I have a Pixhawk 2.4.8 which is acting weird. When I simply plug into any USB port to power it up, it just beeps non stop.

I believe the firmware is corrupted.

Mission Planner will not connect to it so I can flash the firmware.

Is there any other progra

Read more…
6 Replies