I am little confused about two GPS setup.

1. My main GPS is a "Here GNSS" with 8 pin connector which will go into GPS-1 Port.

2. Now the 2nd GPS port on Pixhawk 2 is 7 PIN connector!

Do I need a specialized GPS for the 2nd GPS? or I can order a "Here GNSS GPS" with a 7 pin connector? if yes from where?

Furthermore, are there any GPS extension cables available for "Here GNSS" GPS?. The standard length is not enough for my application.

Lastly, do I have to do anything special inside the Mission planner to enable both GPS.

Any gotchas, you guys know I can learn from.

Thanks for your help.

Views: 70

Replies to This Discussion

Any takers in this group can help?

This is one dead group for sure...



Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service