All Discussions (245)

Sort by

UgCS direct connection

In the past we have had issues with the UgCS for DJI not connecting to the laptop.

From reading some of these discussions we are not alone.

Is there any thought of connecting the PC running UgCS directly with the transmitter via USB? You would be tethe

Read more…
5 Replies

UgCS DAT files

Hi, I just discovered the mission DAT files on my android tablet running UgCS for DJI.

These seem to be different to the DJI DAT files stored on the drone itself. I tried uploading them to CsvView to convert to a CSV file but it wouldn't read it. Is t

Read more…
5 Replies

UgCS Mapper

Is there any documentation or tutorials on UgCS Mapper? I DL'd UgCS Mapper and tried it on a few different data sets which matched closely to Agisoft's camera alignments. I just didn't really see much of a time improvement in photo matching between t

Read more…
1 Reply

Mission error

I’m getting an error that the radius of the mission is above the acceptable limit. Never seen this before. I did run a firmware update on my dji inspire 1 pro. any ideas. Im in the field and cannot fly

Read more…
9 Replies

Multiple Emulated Drones

I'd like to fly more than one emulated drone simultaneously. The website says that I can fly "unlimited multi-drones", which I would like to think includes emulated ones (as they are important to avoid later collisions between multiple drones in the

Read more…
19 Replies

RTL AGL

Feature request. Have UGCS auto calculate a safe RTL AGL altitude. This would consider situations where RTL might be triggered via loss of telemetry or low battery on the back of a hill, as the RTL is relative to the home location, it would need to b

Read more…
1 Reply

Udp connection

Hello

I can't seem to connect to my vehicle via udp/wifi connection. I can connect with both mission planner and qcg with my setup

My setup is as follows

pix2

raspberry pi 3 (handles networking and mav proxy)

quad plane running arduplane 3.7

futaba t8fg su

Read more…
8 Replies

DJI Inspire2 not accepting auto mode

Hi all. 

I'm having trouble with an Inspire2 photogrametric mission. When I try to start (auto mode) it shows the following message: 

Auto mode failed - the radius of mission is over the acceptable limit. 

If I takeoff in manual mode, I see I cant go fu

Read more…
5 Replies