Share 'Important: ArduPilot users, change your throttle wire to pin 11'
We've changed the channel that reads the throttle on basic ArduPilot from pin 13 to pin 11. That's because pin 13 shares an LED, and it's causing problems with some low-voltage RC receivers. Pin 11 is clean.
The above picture shows the correct jumper wire configuration. If you've been using pin 13, please switch it to pin 11.
In the code, you tell ArduPilot which pin you're using with this lin…
You can share this blog post in two ways…
Share this link:
Send it with your computer's email program: Email this