Share 'Adding servo to aux channel 1 - How do I do it?!'
I've been stuck on this for a while. How do you set up a spare channel to run a servo through the aux outputs?
This is what I have tried:
Go to APM planner > Initial setup icon > Optional setup > Camera gimbal
Then assign 'Tilt' to RC9 and set input channel to, say, Ch7 which I have spare.
I am told elsewhere the RC9 outputs to output 1 on the pixhawk (also know as pin 50 apparently)
You can share this discussion in two ways…
Share this link:
Send it with your computer's email program: Email this