Share 'Need step by step guide for Storm32 SBUS connection to PX4'
was anybody able to make this board to communicate with pixhawk via sbus?
I see some instructions here:http://www.olliw.eu/storm32bgc-wiki/Configure_the_RC_Input#S-Bus
and I connected sbus out from PX4 to rc-0 pin. I set virtual channel configuration to SBUS.
I went to MP on pixhawk side, set BRD_SBUS_OUT=1 so it would pump out servo channels via sbus out, then set MNT)TYPE=1 for servo.
You can share this discussion in two ways…
Share this link:
Send it with your computer's email program: Email this