Share 'Problem on connecting gimbal to the pixhawk by serial/telemetry interface'
I want to update this issue. I’m trying to get the serial interface of 3 axis gimbal controls to pixhawk through the telem2 port.
Connecting the gimbal controller serial pins (tx, rx & gnd) to the pixhawk telem2 pins as a below order. Rx to Rx Tx to Tx & Gnd wire connected to the any one of the ground pin.
The following setup has been carried out through the GCS
You can share this discussion in two ways…
Share this link:
Send it with your computer's email program: Email this