So ya, finally got my SW all built. The system is built like this:
(EZUHF > ppm sum out to > APM2.0 (powered by 5v bec on output8) > servos (chan1-7)
So ya, on bootup all 4 wing servos work fine, but after 10-15 seconds only channels 1-4 continue to r
Read more…I am configuring apm2 on my Zephyr2. I have the throws down to about +-35% on my futaba9c. In mission planner I configure, and then set the endpoints for each channel. I save and boot up the plane in manual mode... reduced throws work perfect! I
Read more…So I had the following setup on my benchtop and ran into a snag. I want to verify that there are no issues from the APM side of the hardware loop.
Problem? RcRx stopped operating after being powered (by 5.0V DC on the RcRx and 5V from USB on the ap
Read more…Is there a way to trigger/jump to a new navigation command based on a low MAH level or voltage drop? I'm wondering about this as a safety measure for high altitude / long range flights over the corn fields here. The type of behavior in which I'm in
Read more…