When I plug in a USB to mission planner my flight controller is functioning fine, but when I disconnect and just run from the lipo the voltage goes down to 3Vdc.I have checked the power module and I am getting 5Vdc output from it.All the rails have 3
Read more…What I am trying to do is use channel 8on APM to activate a electronic switch.I have verified it is working by using Channel10 and can see it operating, but when I assignChannel 8 it does not work at all.I have put CH8 Opt to Relay On/off and alsoAss
Read more…Puchased a JD Drones IO Board as i would like to fire up some LED's from the APM2.8 Controller
Has anyone any code or can give any assistance with this as their is not much out
there for setting this up correctly.
I can read and write to it from the jD-
