I`m trying to get Mission planner connected to my Pixhawk through RPI using UDP protocol. But somehow it fails. If i`m using APMplanner 2 everything is working and connections is good.
When i hit the connect button in mission planner it`s saying "w
My first test was successfully completed with 50km using gamepad in Cruise mode.
After 50Km i had 50% battery remaining.
I also had Live video stream and telemetry connected to MP.
I will soon post a video of my setup and its performence.
I just want to share the result using raspberry pi with Gstreamer to stream live video from my Hexacopter.
I also stream telemetry through Rpi. Resolution 800x448
Big thx to Tommy Larsen for the time and effort and making this possible.
Im working on a project where im trying to stream video/pictures in a very low quality from my APM board through to Mission Planner using GPRS/3g (Dronecell)
My big question is, would this even be possible to carry through? and if so, what frame siz
After several successfully flights with 3s lipo and standard PID settings i decided to change out my 3s with 4s 5000mAh batteries.
But something stranges happen during waypoint flight in AUTO mode.
It was set to climb 150meters in a 1km flight
I want to add these lines to arducopter software for Serial3 or telemetry:
AT+CGATT? //attached to GPRS ?
AT+IFC=2,2 //"it's better to use hardware flow control"
AT+CIPMODE=1 //Enable transparent mode
AT+CSTT="internet" //set APN
Im trying to get my dronecell up and running.
i have connected the cell through TX0/RX0 Ardunio 2560. Serial connections is working.
It respons to my AT command, but during startup it throwing CPIN NOT DETECTED.
I belive it not sensing the sim car