Bob's Discussions (17)

Sort by

Bicopter Support Please

Are there any plans to add support for a bicopter configuration such as (Avitar type).

Apparently you can use a KK board to fly one manually,But it would be great if the code could support the configuration so we can fly auto missions etc.

Read more…

Hil Firmware on a Pixhawk

I am wanting to install the Hil firmware on to a pixhawk to do some simulations in xplane but keep getting upload errors.Works fine on APM.

Is this possible to do with a pixhawk?

Read more…

Setting up multiple failsafes

I am wondering how multiple fail safes can be set up such as in this situation.

If i am flying in Auto mode and the plane flys out of range of my rc transmitter the plane continues in auto mode. I have been able to achieve this just by setting the fai

Read more…

updated firmware now problem with stabilize.

I just updated the firmware on my amp 2.5 and now in stabilize mode if i bank the plane right the elevator goes up and if i bank it left the elevator goes down ,the elevator should not even be moving the ailerons should be.

everything is connected cor

Read more…

Antenna Tracking using Pololu Maestro

I have just finished building an antenna tracker and am trying to get it to work with mission planner,

I have the servo's and movement setup in Maestro but mission planner will not connect to the servo board I keep getting this error.Have all the driv

Read more…

three 3dr radios

Is it possible to have two ground stn radios and one radio in the uav,

I want to have a radio on the ground connected to a laptop running mission planner and the other connected to a tablet running droid planner.

The tablet would be used for monitoring

Read more…

Antenna Tracking

Looking up Antenna Tracking in the arduplane wiki and it describes Automatic camera tracking instead of how to setup antenna tracking? I think it has the wrong heading

Where can i find info on setting up Antenna tracking and not camera tracking.thanks

Read more…

No RC Receiver message

3691073617?profile=originalMy first flight today with a amp 2.5 installed in a fpv phantom wing the flight was great in manual .

Though I do have a few issues first is this message no rc receiver in mission planner yet everything is connected up?.

Read more…

quadcopter not level in mission planer hud

After installing the new 2.9 firmware the hud in the mission planer is tilted to the left by about 10 degrees.

I have done the calibration followed the video and steps tilting the quad in all directions as directed but the hud is still tilted to the o

Read more…

Exif data to GPX

Is there a way to create a GPX file from and image that has gps data in its Exif

I am trying to use Palentier to overlay images onto Google earth but it requires you to load the jpg image and gpx track data in order to match it up and then export as a

Read more…

Auto Landing

I have been practicing auto landings on the computer using xplane 10 and am wondering if there is a way to make the plane flair before touch down as the landings are to hard and the plane slams into the ground. So is there a way to program in mission

Read more…

In Flight mission Plan

Just wondering if it is possible to upload a mission plan while the plane is in the air.

I know you can click on the screen and click fly to here while plane is in air but wondering if

One person takes off and flies the plane manually and another write

Read more…