Please see attached log and screenshot.
Flying mission with auto takeoff and waypoints. Plane perfectly executes take off and heads to first waypoint. Upon arrival at first waypoint plane pitches down until impact - even
Read more…I loaded Plane 3.2.3 so I could try terrain following. Everything seemed fine, no errors, but no output to the ESC or servos in any mode. The mode switch works because I can see the modes change in Mission Planner.
I noticed the IO B/E Led was glowin
Read more…Hi,
I have a flying wing with PixHawk "mostly" working. Sometimes it seems to have a problem with altitude when in auto mode and flying a waypoint mission. Here's what it does:
Fly RTL mode OK
Fly manual mode OK
Switch to Auto with preprogramed waypoint
Read more…Hi,
I've got:
APM 2.5
3dr airspeed sensor
3.x firmware
Can't get the airspeed to zero even when pitot is covered. Tried the preflight calibration button but that had no affect. It fluctuates between 4 and 6. Any ideas how to get AS to show 0 on the fligh
Read more…Hi,
Just got my wing with APM 2.5 flying. Stabilize works great, but Loiter just sort of flies away. The plane will circle overhead, then the next circle is a bit further down wind, the next circle is so far away I have to switch to manual and fly it
Read more…Hello,
on APM 2.5...
My throttle only works in Manual mode. If I switch to any of the assisted modes the throttle is turned off. I read that the plane must be in motion before the throttle will work in assisted modes but this is not the case in with my
Read more…Hi All,
When I connect with a USB cable I get:
Solid green LED
Quick flash of blue and orange LED. They are off while connected.
Does NOT show up in Device Manager. No Com port. No recognition by windows whatsoever.
Any ideas?
Thanks!
Brian
Read more…
