All,I have an APM2.5+ w/ enclosure (allows vertical adaptors) that i would like to sell. I found out recently that my 3.3V regulator was blown and I do not want to attempt to open it up and fix this. This was purchased directly from 3drobotics in Jan
Read more…I am having some major problems and was hoping that someone can please help me determine what is wrong and give me more direction on what else to check. I have my quad setup setup with APM2.5 and ArduCopter 3.1.2. Trying to do my maiden flight but ca
Read more…I am updating my ArduCopter software to 3.1.2 on a APM 2.5 and am doing the ESC calibration for Afro 30A ESCs (they have SimonK update also)..
I have completed the radio calibration already. I put my throttle stick to max throttle and plug in my li
Read more…I have cleared my EEPROM and am trying to do a clean update to ArduCopter 3.1.2 for my Quad. I am using the wizard to go through the initial setup process. Everytime I get to the Accel Calibration, I start to have problems...
Whenever I am asked to
Read more…I am starting to get my ArduRover configured and am having some trouble with getting basic functionality from my radio to my steering servo. I have APM2.5+ and have loaded ArduRover2.20B via Mission Planner (version 1.2.35 mav 1.0). I am trying out
Read more…All,
I am writing some custom code for my APM2.5 and am having trouble mapping the I/O pins that are brought out on the enclosure against the Mega 2560 pin outs. I have the APM2.5 schematic and have the Mega 2560 mapping. Trying to get a Radio RX o
Read more…All,
I am writing some custom code for my APM2.5 and am having trouble mapping the I/O pins that are brought out on the enclosure against the Mega 2560 pin outs. I have the APM2.5 schematic and have the Mega 2560 mapping. Trying to get a Radio RX o
Read more…I am new to Arduino programming and am learning the language from the basics. I downloaded Arduino w/Autopilot application for my PC and have the APM2.5. I have a short program that I wrote that I want to upload to the APM.
I have gone through and c
Read more…I am attempting to get all my ArduCopter development environments setup on my MacBook Pro w/ OSX but keep getting errors when I try to "Verify" the sketch in the Arduino IDE (patch version from diydrones download page).. Here is what I have done and
Read more…