When I disconnect my RC input from the pixhawk my throttle does not drop, it stays at whatever i left it at. So now if it comes unplugged during flight it's going to fly away.
Does anyone have info regarding this?
Thanks,
Colin
Read more…So I just finished setting up my X8 Octo to run on 5S and decided to do a full test flight. I flew for about 7 minutes, lost a prop and then the whole thing flipped.
Here is a link to the crash http://youtu.be/XCinEiDRB08
I could hear the X8 didn't s
Read more…I just got a ezUHF tx with an 8 channel diversity receiver and am having some issues with it. I did a recalibration of the ESC's but it wouldn't let me to it though the APM so I had to put in each individual ESC to the throttle to calibrate. Next p
Read more…https://www.youtube.com/watch?v=jC6W9XVJRA8
Does anyone have an idea what happened here?
I Launched in stabilize mode, switched to loiter (at around 30 seconds) and then it decided to do its own thing. I did 4 successful flights the day prior and the on
Read more…Just built a new quad and the motors won't start until half throttle. I calibrated all the motors individually through the receiver first and they start right away. I then go to do the auto calibration with the motors plugged into the AMP and they
Read more…My USB connection broke off the APM board, is there any way around using the usb port? Is it possibly to use the telemetry pins to connect to it? I also have the the ground link of the 3dr telemetry can i connect that physically to the telemetry po
Read more…I was flying my hex today, as I was headed toward my current position it decided to not respond to my controls and keep going over me. It was about 100 feet up then looked to increase altitude a bit and kept going away. It seemed to level off and he
Read more…I currently have a hex which is my first build. I'm looking to build a new copter for aerial video and I would like to know which configuration (eg. hex, octa, y6) would be best. If there is no definite answer please let me know what your opinion i
Read more…I have been having an issue lately with some of my ESC not arming when powering on my hexacopter.
What happens is when I power on the hex, sometimes up to 4 motors won't initiate when arming but not consistently all 4 (sometimes only 2 don't start).
Read more…I searched the forums and wiki and can't find how to add the graph for sonar. I assume when you load the log and choose the option to graph it there should be an option to choose sonar alt but i can't find any such graph option. I feel like I must
Read more…Hi all,
Today I installed a voltage sensor on my Hexacopter and tested is successfully with my 3DR telemetry. Shortly after the telemetry wouldn't connect. After much troubleshooting and verifying that the 3DR radio's could communicate with each oth
Read more…